The chain tensioner damper mounts on top of the cam chain tensioner shaft. Its purpose is to dampen vibrations transmitted from the cam chain. You should consider replacing this part during and engine rebuild as after time the rubber will harden and may break off.Dont risk it, just replace it. Suits..
Need the lower chain slider for your ATC70, we have you covered. This remade part is now available.The lower chain slider acts to guide the chain and is commonly worn out. Replace your old worn slider now and avoid costly damage in the future. Suits ATC70 from 73-85..
Been looking for new Decals for your classic 77 entry model FL250. So have we, and now thanks to owner Joe from Washington generously supplying the samples we can now offer these.As always, hand drawn with registration defects corrected and clear laminated these decals will replace your old faded or..
The panel damper rubber is located in the rear brake panel on 73-74 models. It serves to anchor the brake panel but also allows a small amount of movement and damping when the brake is applied.Suits ATC70 from 73-74..
Rear Fender Decals for the ALT, These decals are very hard to find but we have them. Quality reproductions created from originals means the colours are true and the lines crispNote, these models were offered with either yellow or orange plastics, This decal suits models with Yellow PlasticsSuit..
Here is a nice set of reproduction side decals to suit 1983 model Yamaha YTM175 Tri MotoDecals are scanned from originals and colours are true to suit the fussiest restorer. Top that with a clear laminate overlay for extra wear and fuel spill protection and your on a winner.Suits Yamaha YTM175 1983 ..
Got worn rings on your ATC110, Bore still OK but just needs a freshen up. This will fix it, Get this .25MM oversize ring set to replace your worn existing ringsSuits ATC110 81-85Please note, Image shown is not correct for this part...