The chain tensioner damper mounts on top of the cam chain tensioner shaft. Its purpose is to dampen vibrations transmitted from the cam chain. You should consider replacing this part during and engine rebuild as after time the rubber will harden and may break off.Dont risk it, just replace it. Suits..
Need the lower chain slider for your ATC70, we have you covered. This remade part is now available.The lower chain slider acts to guide the chain and is commonly worn out. Replace your old worn slider now and avoid costly damage in the future. Suits ATC70 from 73-85..
The guide roller bolt locates the guide roller within the cylinder. If you ever wonder what the little hex head bolt was for that goes on the left side of the cylinder now you know. Don't remove it out of curiosity. Although this bolt rarely wears out it is sometimes lost during disassembly and shou..
Brake pedal spring, works to retract the brake pedal after application, if this spring is fatigued or missing brake drag and damage may occur.Suits ATC90 70-78, ATC110 79-82Please note: image shown is not correct for this part...
Front axle nut with flange 14mm. The axle nut is subject to abuse and damage and should be replaced as required.Hex type castle nut suits ATC70 models from 78-85. Also suits ATC250R 81-82 Front Wheel and Swingarm. ATC200E and 200ES 82-84, ..
Rear Axle Circlip Retainer, Holds axle circlip in place.Be sure to replace this item whenever it becomes damaged as it performs an important function in securing your axle. Suits ATC250R 85-86, ATC350X 85-86Also suits TRX250R 86-88, TRX250X 87-88 & 91-92, TRX300EX 93-08, TRX450R 04-05, TRX450ER ..
This is the felt seal used to prevent contaminants from entering the brake panel. It also holds lubricant that ensures the shaft moves freely.It is located on the inboard side of the brake cam shaft. This is the shaft that operates the brake shoes when the brakes are applied.Suits ATC70 73-74, ATC90..
These mud flaps although not standard issue on 2nd gen ATC70s were offered as an accessory.Now discontinued and extremely hard to find we had these remade from a NOS sample.They are interchangeable so fit either left or right side. This means if you only need one you are not forced to buy a pair.We ..
Here is a nice reproduction Mud Flap for late ATC90 and early ATC110 models. Also can be fitted to ATC185S but are not as long down the side, (ATC185S has 3 side bolts, these have 2). Previously near impossible to find we had these remade. Sold per each but are reversible so if you only need one you..
Headlight Switch Mount. This part is mounted in the top of the ATC headlight and locates the headlight switch. Part is moulded from a NOS part so will replace your old rotted or missing mount rubber perfectly.Suits ATC90 70-78..
This is a small and often forgotten item but it performs an important job in locking the rear fender down to the frame. This reproduced rod is an exact copy of the original. the rod thickness is correct so it fits properly within the frame. It has the correct factory crimps to keep it in place and s..