This is the step washer that goes between the bolt and plastic fender which locates the plastic. Often lost or rusted this item plays an important role in allowing the mount bolt to be tightened down without damaging the plastic. Replace these washers when needed to avoid damage to expensive fenders..
This is the set spring fitted to various ATC pull starters. Without this item the starter ratchets may not return properly and cause damage to the pull starter and starter cage. Suits ATC90 70-78, ATC110 79-85, ATC185/S 80-83, ATC200 81-83, ATC200E 82-83 ATC200S 84-85. sold per set of 3.DOES NOT SUI..
This is the starter ratchet fitted to the ATC70 starters. These items rarely wear out but somehow seem to dissapear for no real reason. If you are having problems with these jumping out of the starter spool check to see if you spool ramps are worn as these ratchets are hard steel and almost never we..
This is the starter ratchet fitted to the ATC90 starters although will fit most model ATCs with pull starter. These items rarely wear out but somehow seem to dissapear for no real reason. If you are having problems with these jumping out of the starter spool check to see if you spool ramps are worn ..
The stator plate on the ATC70 can, at times be very difficult to removeThe sticking point is the screws that retain the plate to the inner casing. Most often these screws will be damaged in the process and should be replaced. You might think you can re-use the old ones 'cos you're never going to do ..
This is the seat mount rubber that goes between the seat and frame. be sure to replace this item when work as it contributes to seat alignment. Suits ATC70 73-74Also suits SL70 71-73, XL70 74-76, XL80S 81-85, XR75 73-78, XR80 79-84,..
Rear Fender to Frame mount rubber, This part plays an important role in securing and aligning the rear fender to the frameIf this part is worn or missing damage can occur to fender and or frame. Suits ATC90 70-78, ATC110 79-85, ATC125M 84-85...
This is the small rubber umbrella that goes under the starter handle on US90 models, it prevents dirt and grit from entering the recoil start mechanism so plays an important role. You should always replace this part if it is damaged or missing to prevent expensive damage to your recoil starter.Suits..
This is the steering head nut that fastens the front forks in to the frame. Regular maintenance calls for the steering head bearings to be lubricated and this item should be replaced at the same time if corroded or damaged. Correct for 78-85 model ATC70 but also can be used on 73-74. Suits ATC70 78-..
Need an new starter handle for your ATC but don't need OE pricing, this is it. Get this reproduction starter handle and get started. suits ATC70 all, ATC90 all (not US90 model) and ATC110 79-82.Note, item is similar to image shown but not exact...