Dont put up with that damaged tappet cap any longer, it really detracts from the look of the engine, just get this OE Honda cap and you engine will thank you. Suits ATC90 70-78, ATC110 79-85, ATC125M 84-85Also suits CL90 67-69, CM91 66-69, CT90 66-79, S90 64-69, SL90 '69, ST90 73-75...
This is the set spring fitted to various ATC pull starters. Without this item the starter ratchets may not return properly and cause damage to the pull starter and starter cage. Suits ATC90 70-78, ATC110 79-85, ATC185/S 80-83, ATC200 81-83, ATC200E 82-83 ATC200S 84-85. sold per set of 3.DOES NOT SUI..
This is the starter ratchet fitted to the ATC70 starters. These items rarely wear out but somehow seem to dissapear for no real reason. If you are having problems with these jumping out of the starter spool check to see if you spool ramps are worn as these ratchets are hard steel and almost never we..
This is the starter ratchet fitted to the ATC90 starters although will fit most model ATCs with pull starter. These items rarely wear out but somehow seem to dissapear for no real reason. If you are having problems with these jumping out of the starter spool check to see if you spool ramps are worn ..
The stator plate on the ATC70 can, at times be very difficult to removeThe sticking point is the screws that retain the plate to the inner casing. Most often these screws will be damaged in the process and should be replaced. You might think you can re-use the old ones 'cos you're never going to do ..
This is the small rubber umbrella that goes under the starter handle on US90 models, it prevents dirt and grit from entering the recoil start mechanism so plays an important role. You should always replace this part if it is damaged or missing to prevent expensive damage to your recoil starter.Suits..
Need an new starter handle for your ATC but don't need OE pricing, this is it. Get this reproduction starter handle and get started. suits ATC70 all, ATC90 all (not US90 model) and ATC110 79-82.Note, item is similar to image shown but not exact...
This is the pull starter cage fitted to ATC90 and early ATC110 models with 3 bolt cage. This item often wears when the starter pawls fail to retract fully after the engine starts. This item should be replaced when wear is detected to prevent possible damage to the starter and flywheel/stator should ..
Replace that old broken recoil spring and stop push starting your ATC. This spring is a direct replacement for ATC90 all. also suits ATC110 79-84, ATC185/S 80-82, ATC200 81-82, ATC200E 82-83.DOES NOT SUIT ATC70..
If you have problems with continually breaking your starter rope then this may be the answer. Virtually unbreakable, made from wire cable similar to handbrake inner cable and coated with plastic. Good for high compression and modified engines...